Jeep

Home / Jeep / Page 4

We Service and Repair all Jeep cars

  • 2009 Jeep Compass

    Jeep Compass
    Mileage
    152,702
    Service Date
    6/4/2020
    Services Performed
    • Install data scanner and engine analyzer. Run tests on the body controller and anti lock braking system computer control units. Remove fault codes from the processors memory. Codes exist in the system for the passenger side, rear wheel speed sensor erratic signal (C1032), implausible data received from ABS (U0415), and AWD system temporarily disabled (C145F). Perform all necessary pin point tests checking the wiring, grounds, relays, and related circuit components to isolate the problem to the passenger side, rear wheel speed sensor being faulty which will be covered under warranty. Replace the wheel speed sensor assembly, clear the codes, and road test the vehicle to confirm repairs.
     
    Charlie N. gave our service a 5 star review on 6/6/2020
  • 2009 Jeep Compass

    Jeep Compass
    Mileage
    150,562
    Service Date
    12/3/2019
    Services Performed
    • Price includes mounting, balancing, valve stems, flange machining, and tire disposal.
    • One lug nut of the 20 on the vehicle was seized. All the other lug nuts on the vehicle were torqued to the proper specification. Drill out the old stud and lug and install new lug nut and stud on the right front of the vehicle.
     
    Charlie N. gave our service a 5 star review on 12/30/2019
  • 2008 Jeep Compass

    Jeep Compass
    Mileage
    146,484
    Service Date
    11/26/2019
    Services Performed
    • Right front headlight out
     
    Edward D. gave our service a 5 star review on 11/27/2019
  • 2009 Jeep Compass

    Jeep Compass
    Mileage
    149,493
    Service Date
    10/18/2019
    Services Performed
    • Decided to replace both rear bearings. Labor covered internally, not under labor warranty, parts only.
     
    Charlie N. gave our service a 5 star review on 10/20/2019
  • 2008 Jeep Compass

    Jeep Compass
    Mileage
    145,275
    Service Date
    8/28/2019
    Services Performed
    • Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipd vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufactures specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
     
    Edward D. gave our service a 5 star review on 8/29/2019
  • 2009 Jeep Compass

    Jeep Compass
    Mileage
    143,975
    Service Date
    1/22/2019
    Services Performed
    • Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipd vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufactures specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
     
    Charlie N. gave our service a 5 star review on 1/28/2019
  • 2008 Jeep Compass

    Jeep Compass
    Mileage
    138,669
    Service Date
    12/29/2018
    Services Performed
    • There are no codes in the system and no issues were experienced during road testing. The air flow readings are slightly below normal and the air filter is partially blocked. Recommend replacement of the vehicles engine air filter. If the issue returns, additional testing will be required.
    • Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipd vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufactures specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
    • Remove calipers, clips, and bracket assemblies. Remove the front disc brake pads and clean and lubricate the caliper slides. Replace the front brake rotors and install new brake pads. Perform all necessary system adjustments and vacuum bleed brake calipers. Top off master cylinder to proper level, and road test vehicle.
     
    Edward D. gave our service a 5 star review on 12/30/2018
  • 2014 Jeep Patriot

    Jeep Patriot
    Mileage
    24,294
    Service Date
    9/26/2018
    Services Performed
    • The vehicles throttle body has failed causing the light to illuminate. Remove the old unit and clean the sealing surfaces. Replace the throttle body with an updated / revised unit from Jeep. Install and solder in new required wiring harness and reassemble the engines air intake components. Reset the processors memory, and perform the necessary throttle angle relearn specified by Jeep. Road test the vehicle and check for pending issues with the system in the computers memory.
     
    Charlie N. gave our service a 5 star review on 9/29/2018
  • 2009 Jeep Compass

    Jeep Compass
    Mileage
    140,927
    Service Date
    8/22/2018
    Services Performed
    • Remove the Rear suspension components necessary to access the rear hub assembly. Remove spindle and press out the existing hub and bearing assembly. Clean spindle bore and check for warpage. Install new Passenger Rear wheel bearing and hub assembly. Press the existing hub assembly into the new bearing and set the ABS wheel speed sensor air gap, if necessary. Torque spindle mounting flange to specification and reinstall removed components. On ABS and or traction control vehicles, install data scanner and reset computer memory. Road test vehicle and verify that the ABS and traction control circuits are all within parameters.
     
    Charlie N. gave our service a 5 star review on 8/24/2018
  • 2008 Jeep Compass

    Jeep Compass
    Mileage
    132,783
    Service Date
    8/8/2018
    Services Performed
    • Change engine oil and engine oil filter. Lubricate accessible grease fittings on vehicle chassis. Check and or set tire pressures. Check and or top off all low fluid levels.
     
    Edward D. gave our service a 5 star review on 8/9/2018