2011 Subaru Outback
Mileage
176,870
Service Date
1/17/2025
Services Performed
- Inspection of the clutch hydraulic system revealed that the slave cylinder and the hose going to the slave cylinder were leaking. Vacuum the contents of the clutch master cylinder reservoir. Remove all necessary components to access the slave cylinder body and lines. Remove the slave cylinder lines and clean the line flares and threads to remove debris. Remove the cylinder mounting bolts and remove the old cylinder assembly. Place the new slave cylinder assembly on the bench bleeding machine and bench bleed the unit to remove assembly lube, air and dirt from the manufacturing process. Clean the pivot and cup assemblies and lubricate the ends. Install the new slave cylinder on to the vehicle and torque the fasteners to specification. Reinstall the hydraulic supply line and fill the reservoir of the clutch master cylinder. Hook the vehicles clutch system to the vacuum fluid exchanger and run the machine to flush the entire hydraulic system using new fluid. Pressure test the hydraulic system and check all components for leaks. Reinstall removed shields and road test vehicle. Verify that the reservoir is filled to capacity and no leaks are present.
- Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipped vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufacturers specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
- Replace fog light bulb
Robert R. gave our service a 5 star review on 1/18/2025
