2019 Kia Sorento
Mileage
61,134
Service Date
6/26/2024
Services Performed
- Remove the vehicles wheels in order to gain access to the outer tie rod end. Remove any components that interfere with the removal of the tie rod end (braking components, shields). Remove cotter pin and the hardware that attaches the tie rod end to the spindle and adjusting sleeve. Remove the faulty tie rod end and clean the threads in the adjusting sleeve. Apply anti-seize compound to the threads of the new tie rod end and install into the adjusting sleeve and spindle. Tighten all hardware to manufacturers specification and grease all applicable joints on the steering components and reinstall vehicles wheel. Since the steering components were disassembled, a 4 wheel alignment is needed to set vehicles steering characteristics back to original specifications.
- Road test the vehicle to verify any alignment concerns. Check and or set all tire pressures. Install targets on the vehicles wheels, and take initial alignment measurements. Adjust the factory toe angle to specification, and verify that the other alignment angles on both the front and rear axles are within specifications. Note: Shims, Eccentrics and labor for fixed alignment angles in both the front and the rear are not included.
- Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipped vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufacturers specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
- Remove the cabin air housing to access the interior cabin air filter. This filter is responsible for filtering the air used for the heating and air conditioning in the vehicle and removing harmful particulates. Vacuum the inside of the filters housing and replace the cabin air filter with a new unit. Reinstall the access covers and test the air flow from the vents.
- Remove the air intake hose from the plenum chamber and disassemble the filter housing. Remove the existing engine air filter and vacuum the inside of the filter housing. Install the replacement filter and resecure the air intake pipes to the plenum chamber.
Michael F. gave our service a 5 star review on 6/29/2024
