2013 Subaru Outback
Mileage
127,482
Service Date
4/7/2023
Services Performed
- Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipped vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufacturers specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
- Repair Exhaust
- A month ago, the car would not start. eventually started and CEL came on. Had cam and crank codes. system has been cleared and reset. check to make sure everything is ok. See note.
- Visually check the vehicles lighting system to confirm customer condition. After inspection it was found the both low beam headlight are out. Remove the vehicles front wheels. Remove any trim interfering with the removal of the inner fender liner. Remove the vehicles fender liner in order to access the rear of the headlight housings. Remove the old bulb(s), and clean and tighten the electrical terminals. Install a new low beam headlight bulb, and reattach the electrical connections and locks where necessary. Clean the previously removed hardware and reinstall the removed shields and covers. Test the operation of the vehicles lighting system to confirm that the lighting is operating properly. Verify both high and low beam head lamp alignment using a projection aligner and adjust as required.
Terry S. gave our service a 5 star review on 4/8/2023
