2013 Hyundai Sonata
Mileage
175,921
Service Date
12/7/2023
Services Performed
- Price includes mounting, balancing, flange machining, tire disposal, and resetting / relearning of the tire pressure monitoring systems data, and sensors where necessary.
- Road test the vehicle to verify any alignment concerns. Check and or set all tire pressures. Install targets on the vehicles wheels, and take initial alignment measurements. Adjust the factory toe angle to specification, and verify that the other alignment angles on both the front and rear axles are within specifications. Note: Shims, Eccentrics and labor for fixed alignment angles in both the front and the rear are not included.
- Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipped vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufacturers specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
- Replace Fog Light Bulb
- Remove the vehicles wheels in order to gain access to the Left outer tie rod end. Remove any components that interfere with the removal of the tie rod end (braking components, shields). Remove cotter pins and hardware that attach the tie rod end to spindle and adjusting sleeve. Remove the outer tie rod end and remove bellows from the rack and pinion. Install an inner tie rod end removing tool and finally remove the tie rod end from the vehicle. Apply thread lock to the threads of the new inner tie rod end and install onto the rack and pinion. Tighten to specification and reassemble all previously removed components, in reverse order, back to original configuration. Tighten all hardware to manufacturer specification and grease all applicable joints on the steering components and reinstall vehicles wheel. Install 4 laser heads on vehicle and take initial measurements. Adjust factory toe angle to specification and road test vehicle to confirm repairs. Aligning the vehicle is necessary due to disconnecting the vehicles steering system. Note: Shims, Eccentrics and labor for fixed alignment angles in both the front and the rear are not included.
Sherry O. gave our service a 5 star review on 12/7/2023
