2010 Ford Edge
Mileage
253,482
Service Date
5/22/2019
Services Performed
- Inspected the A/C system for leaks and found the compressor is leaking at the clutch and body of the unit. Install refrigerant recycling equipment on the system and remove any remaining system pressure and oil. Clean all exterior connections requiring servicing to remove debris. Remove brackets, hoses, harnesses, and access covers to access the air conditioning compressor. Remove compressor manifold, serpentine drive belt and mounting bolts. Clean manifold lines and replace necessary o-rings and seals. Install new unit onto vehicle and reassemble components. Align compressor pulley and torque mounting bolts. Reinstall serpentine drive belt and assemble removed covers, shields, and harnesses. Vacuum system for 30 minutes to remove any moisture. Fill system to capacity with new esther oil, dye, and refrigerant. Clean condenser fins and inlet and outlet air passages. Run engine to operating temperature and monitor system pressures. Check the operation of the condenser fan, blend door, and check and verify vent temperatures. Check for leaks using dye detection light and insure that all system components are dry. No leaks are present at this time. If the system performance decreases, the customer should return for additional leak testing.
- Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipd vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufactures specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
Scott B. gave our service a 5 star review on 5/23/2019
