- Remove front steering and suspension components and spindles. Remove retaining rings or clips and remove ball joint assemblies from the control arm. Install new hardware and cotter pins. Lubricate all steering and suspension components and check the preload of the spindle. Replace steering and braking system components and clean and perform a wheel alignment and road test the vehicle.
- Road test the vehicle to verify any alignment concerns. Check and or set all tire pressures. Install targets on the vehicles wheels, and take initial alignment measurements. Adjust the factory toe angle to specification, and verify that the other alignment angles on both the front and rear axles are within specifications. Note: Shims, Eccentrics and labor for fixed alignment angles in both the front and the rear are not included.
Jenn T. gave our service a 5 star review on 6/8/2021