2004 Ford Pickup

  • 2004 Ford Pickup

    Ford Pickup
    Mileage
    115,616
    Service Date
    8/1/2019
    Services Performed
    • Vacuum the contents of the brake master cylinder reservoir. Remove all necessary components to access the master cylinder body and lines. Remove the master cylinder brake lines and clean the line flares and threads to remove debris. Remove the master cylinder mounting bolts and remove the old cylinder assembly. Place the new master cylinder assembly on the bench bleeding machine and bench bleed the unit to remove assembly lube, air and dirt from machining. Install the new master cylinder on the vehicle and torque the fasteners to specification. Reinstall vehicles brake lines and fill the reservoir of the new master cylinder. Hook the vehicles brake system to the vacuum fluid exchanger and run the machine to flush the entire brake system using new brake fluid to remove all old fluid from the brakes hydraulic system. Pressure test the brake system and check all components for leaks. Reinstall removed shield and road test vehicle. Verify that the reservoir is filled to capacity and there are no leaks present.
    • Install data scanner and engine analyzer. Run tests on the fuel, ignition, and computer control systems. Retrieve fault codes from the processors memory. Codes exist in the system for the throttle position sensor. Perform all necessary pin point tests checking the wiring, grounds, relays, and related circuit components to isolate the problem to the throttle position sensor. Replace the throttle position sensor, clean the throttle body, and perform the idle relearn procedures. Road test the vehicle and recheck for any hesitation. The vehicle is running as intended at this time.
    • Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipd vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufactures specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
     
    Mark E. gave our service a 5 star review on 8/4/2019

Address

Car Doc, Inc.
4982 E Valley Dr
Walnutport, PA18088-9114
(610) 767-7110

We Service