2013 Subaru Outback

  • 2013 Subaru Outback

    Subaru Outback
    Mileage
    87,106
    Service Date
    10/11/2021
    Services Performed
    • Check the vehicles under hood fluid levels and remove the oil fill cap and breather assemblies (where applicable) Remove the vehicles engine oil drain plug, and drain the contents of the engines oil pan or sump. Remove the filter assembly and clean the sealing surfaces of the housing for reinstallation. On cartridge equipped vehicles, replace the housing O rings and clean the debris from the housing and relief valves. Lubricate the O rings on the housing and or the filter assembly and replace the filter or element. Clean and inspect the oil drain plug gasket, and check the threads in the engines oil pan. Torque the plug to the manufacturers specification using a new gasket where required. Clean the grease zerks to remove debris, and lubricate all accessible fittings on the vehicles steering, suspension, driveline and chassis components. Check and or set the tire pressures and relearn the TPMS system where required. Fill the engine with the manufacturers specified type, grade, and viscosity engine oil and verify level after purging the new filter. Check and or top off all low fluid levels and reset the maintenance reminder system where applicable. Note. Some vehicles maintenance reminders do not take on initial reset. If your maintenance light happens to come on following an oil service, please give us a call so we can correct it.
    • Remove front brackets, adjusters, and pulleys necessary to access the accessory belt components. Remove the engines serpentine and clean and lubricate any idlers, pivots, or tensioner assemblies for later reassembly. Clean the pulley grooves to remove built up rubber and debris that will cause premature wear / noise issues with the replacement belt(s). Check all accessories, idlers, and tensioners for bearing deflection. Replace the accessory drive idler pulley with a used pulley due to excessive bearing deflection and replace the tensioner assembly. Adjust the drive belts to specification, and run the engine to check for proper operation of the idler and tensioner pulleys. Verify belt deflection and alignment of the engines accessories, and lock all manually adjusted tensioners as required.
     
    Ned B. gave our service a 5 star review on 10/12/2021

Address

Car Doc, Inc.
4982 E Valley Dr
Walnutport, PA18088-9114
(610) 767-7110

We Service